Hey there, brewers! Discover the March Nano Brewery Pump - Stainless, the perfect solution for your small 'Nano' commercial brewery. • Robust Flow: With a powerful 17 GPM flow rate, it meets your brewing needs efficiently. • Food - Grade Materials: The pump uses food - grade materials where it contacts the beer, ensuring top - notch quality. • Throttle Back Flow: You can easily throttle back the flow, giving you full control over your brewing process.
*Please Note* - This pump must be taken apart and cleaned after every use to prevent the impeller from seizing. To do so, take the bolts out of the pump head, remove the pump head from the pump, then take the impeller shaft and actual impeller apart. Clean well, and reassemble.
Please note that the pump comes with a three foot cord WITHOUT a plug attached.
Statistics: Motor: 1/8HP 230v/60Hz
- Max Flow: 17 G.P.M at zero head
- Max Head: 27 ft. at 1 GPM
- Inlet: 1' FPT
- Outlet: 1/2' MPT
- Pressure: Max. internal pressure is 200 psi
- Temperature Range: 250F or 121.1C
- Electrical: 230V 50/60HZ
- HP: 0.125
- KW: .093
Materials in Contact with Beer:
- Polysulfone (Impeller)
- Stainless Steel (Front and Rear Housing)
- Buna N (O - Ring)
- Ceramic (Thrust Washers)
- Non - Submersible
- Max. liquid temperature is 250F degrees
- Max. internal pressure is 200 psi
This March Nano Brewery Pump is designed for small 'Nano' commercial breweries. If you find the H315 series too small but don't want to invest in an expensive professional brewery pump, this is the one for you. It has a max flow of 17 GPM at zero head and a max head of 27 ft. at 1 GPM. The inlet is 1' FPT and the outlet is 1/2' MPT. The pump can handle a max internal pressure of 200 psi and a temperature range up to 250F. It comes with a three - foot cord without a plug. After each use, you need to take it apart for cleaning to keep it working well.
